On-Vehicle Inspection [11/2018 - 02/2019]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Hybrid Control / Data List / Accelerator Position Sensor No. 1 Voltage %, Accelerator Position Sensor No. 2 Voltage %.
Powertrain > Hybrid Control > Data List
Tester Display Accelerator Position Sensor No. 1 Voltage % Accelerator Position Sensor No. 2 Voltage % - Read the Data List.
Result
Tester Display Accelerator Pedal Condition Specified Condition Accelerator Position Sensor No. 1 Voltage % Not depressed 10 to 22% Fully depressed 52 to 90% Not depressed → Fully depressed → Not depressed (Accelerator pedal should be operated slowly) Value changes progressively Accelerator Position Sensor No. 2 Voltage % Not depressed 24 to 40% Fully depressed 68 to 99% Not depressed → Fully depressed → Not depressed (Accelerator pedal should be operated slowly) Value changes progressively