LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Hybrid Battery Control System - Service Information (7 Of 7)) >> Combination Switch >> Inspection [11/2018 - ] >> Procedure

Inspection [11/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY 
    1. Inspect EV mode switch (Integration Control and Panel Assembly)
      1. Measure the resistance according to the value(s) in the table below.
        GTY930363Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (EV Mode Switch (Integration Control and Panel Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition
        G32-6 (S) - G32-13 (GND) EV mode switch (integration control and panel assembly) being pushed and held Below 1 Ω
        EV mode switch (integration control and panel assembly) not pushed 10 kΩ or higher

        If the result is not as specified, replace the EV mode switch (integration control and panel assembly).

    2. Inspect NORMAL mode switch (Integration Control and Panel Assembly)
      1. Measure the resistance according to the value(s) in the table below.
        GTY857169Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (NORMAL Mode Switch (Integration Control and Panel Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition
        G32-8 (B) - G32-13 (GND) NORMAL mode switch (integration control and panel assembly) being pushed and held Below 1 Ω
        NORMAL mode switch (integration control and panel assembly) not pushed 10 kΩ or higher

        If the result is not as specified, replace the NORMAL mode switch (integration control and panel assembly).

    3. Inspect SPORT mode switch (Integration Control and Panel Assembly)
      1. Measure the resistance according to the value(s) in the table below.
        GTY857168Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (SPORT Mode Switch (Integration Control and Panel Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition
        G32-9 (P) - G32-13 (GND) SPORT mode switch (integration control and panel assembly) being pushed and held Below 1 Ω
        SPORT mode switch (integration control and panel assembly) not pushed 10 kΩ or higher

        If the result is not as specified, replace the SPORT mode switch (integration control and panel assembly).

    4. Inspect the illumination:
      1. Apply battery voltage to the integration control and panel assembly and check that the switch illuminates.

        OK

        Condition Specified Condition
        Battery positive (+) → G32-12 (ILL+)
        Battery negative (-) →G32-1 (ILL-)        		 Illuminates
        GTY857205Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Integration Control and Panel Assembly)

        If the result is not as specified, replace the combination switch.

scientia non olet · About LEMON Manuals