Installation [11/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL TRANSMISSION REVOLUTION SENSOR (NC)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1 Spacer
1. Install the transmission revolution sensor (NC) and spacer to the counter drive gear sub-assembly with the bolt.
  Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf)
INSTALL TRANSMISSION REVOLUTION SENSOR (NT)
1. Install the transmission revolution sensor (NT) to the automatic transaxle case sub-assembly with the bolt.
  Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf)
INSTALL TRANSMISSION VALVE BODY ASSEMBLY
Refer to INSTALLATION [11/2018 - 10/2019] , or refer to INSTALLATION [10/2019 - ]