Installation [11/2018 - 10/2022]: Procedure

1. Temporarily install the park/neutral position switch assembly to the automatic transaxle case sub-assembly with the 2 bolts.
   NOTE:

   Before installing the park/neutral position switch assembly, remove any dirt or rust on the manual valve lever shaft sub-assembly. Be sure to install the park/neutral position switch assembly straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch assembly cannot be installed correctly.

2. Temporarily install the transmission control shaft lever to the park/neutral position switch assembly.
3. Turn the transmission control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	P
   *b	N

4. Remove the transmission control shaft lever from the park/neutral position switch assembly.
5. Align the protrusion with the neutral basic line.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Neutral Basic Line
   *b	Protrusion

6. Hold the park/neutral position switch assembly in that position and tighten the 2 bolts.

   Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

7. Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the washer and nut.

   Torque: 12.7 N.m (130 kgf/cm, 9 ft.lbf) 

8. Connect the park/neutral position switch assembly connector.

1. Connect the transmission control cable assembly to the transmission control shaft lever as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Correct
   *b	Incorrect

   NOTE:

   Before connecting the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in N.

Refer to PROCEDURE - Step 71 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 71 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 71 [12/2021 - ]

Refer to INSTALLATION [11/2018 - 08/2020] , or refer to INSTALLATION [08/2020 - ]

Refer to INSTALLATION [11/2018 - 10/2023]

See step  2

Refer to PROCEDURE - Step 2

Refer to ADJUSTMENT [11/2018 - ]