LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 58 (Dynamic Radar Cruise Control System (HV) - Diagnostic Codes & Circuit Tests) >> DYNAMIC RADAR CRUISE CONTROL SYSTEM (for HV Model) >> Cruise SET Indicator Light Circuit [11/2018 - 02/2019] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.
WARNING:

Observe the following items for safety reasons when using the Techstream:

  • Before using the Techstream, read the instruction manual.
  • Prevent the Techstream cable from being caught on the pedals, shift lever or steering wheel when driving with the Techstream connected to the vehicle.
    Fig 1: Warning: Do Not Operate The Techstream While Driving The Vehicle
    GTY681287Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  • When driving the vehicle for testing purposes, 2 people are required. One person should operate the Techstream while the other drives the vehicle.
    Fig 2: Warning: Operating Techstream While Driving Could Result In A Serious Accident
    GTY622669Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NOTE:
  • Before replacing the hybrid vehicle control ECU assembly, refer to Registration.

    Refer to REGISTRATION [11/2018 - 10/2019]

  • When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.