Cruise Main Indicator Light Circuit [11/2018 - 02/2019]: Procedure
WARNING: This page is about a different variant/trim than selected.
- PERFORM ACTIVE TEST USING TECHSTREAM (MULTI DISPLAY ALL [WHITE])
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Perform the Active Test according to the display on the Techstream.
Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note Multi Display All (White) Multi-information display (White display) ON - Body Electrical > Combination Meter > Active Test
Tester Display Multi Display All (White) Result
Result Proceed to The multi-information display in the combination meter assembly turns on according to the operation of the Active Test. A The multi-information display in the combination meter assembly does not turn on according to the operation of the Active Test. B
Result:
B
GO TO METER / GAUGE SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]
Result:
A
See step 2
- READ VALUE USING TECHSTREAM (CRUISE INDICATOR)
- Enter the following menus: Powertrain / Radar Cruise1 / Data List.
- Read the Data List according to the display on the Techstream.
Powertrain > Radar Cruise1 > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note Cruise Indicator Cruise control indicator status ON or OFF ON: Cruise control indicator illuminates
OFF: Cruise control indicator turns off- Powertrain > Radar Cruise1 > Data List
Tester Display Cruise Indicator Result
Result Proceed to The cruise control indicator illuminates and turns off according to the operation of the cruise control main switch. A The cruise control indicator does not illuminate but the Data List items change according to the operation of the cruise control main switch. B The cruise control indicator does not illuminate and the Data List items do not change according to the operation of the cruise control main switch. C
Result:
A
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [11/2018 - 06/2020]
Result:
B
REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL [11/2018 - 10/2022]
Result:
C
REPLACE HYBRID VEHICLE CONTROL ECU ASSEMBLY. Refer to REMOVAL [11/2018 - 02/2019]