LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 56 (Engine Starting System (A25A-FXS) - Service Information) >> Power Switch >> Installation [11/2018 - ] >> Procedure

Installation [11/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL POWER SWITCH 
    1. Attach the 2 claws to install the power switch to the lower instrument panel finish panel assembly.
    2. Connect the connector.
  2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY 

    Refer to PROCEDURE - Step 19 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 18 [08/2020 - 10/2022] , or refer to PROCEDURE - Step 18 [10/2022 - ]

  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 24 [08/2020 - 10/2022] , or refer to PROCEDURE - Step 24 [10/2022 - ]

scientia non olet · About LEMON Manuals