Radio Receiver Assembly Communication Stop Mode [02/2019 - 10/2022]: Description
WARNING: This page is about a different variant/trim than selected.
| Detection Item |
Symptom |
Trouble Area |
| Radio Receiver Assembly Communication Stop Mode |
Any of the following conditions are met:
- Communication stop for "Display and Navigation (AVN)" is indicated on the "Communication Bus Check" screen of the Techstream.
Refer to PROBLEM SYMPTOMS TABLE [02/2019 - 06/2020]
, or refer to PROBLEM SYMPTOMS TABLE [06/2020 - 08/2020]
, or refer to PROBLEM SYMPTOMS TABLE [08/2020 - 12/2021]
, or refer to PROBLEM SYMPTOMS TABLE [12/2021 - ]
- Communication stop history for "Display and Navigation (AVN)" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Display and Navigation (AVN)" is 6 or more.)
Refer to PROBLEM SYMPTOMS TABLE [02/2019 - 06/2020]
, or refer to PROBLEM SYMPTOMS TABLE [06/2020 - 08/2020]
, or refer to PROBLEM SYMPTOMS TABLE [08/2020 - 12/2021]
, or refer to PROBLEM SYMPTOMS TABLE [12/2021 - ]
- Communication system DTCs (DTCs that start with U) that correspond to "Radio Receiver Assembly Communication Stop Mode" in "DTC Combination Table" are output.
Refer to DTC COMBINATION TABLE [02/2019 - 10/2019]
, or refer to DTC COMBINATION TABLE [10/2019 - 06/2020]
, or refer to DTC COMBINATION TABLE [06/2020 - 08/2020]
, or refer to DTC COMBINATION TABLE [08/2020 - 12/2021]
, or refer to DTC COMBINATION TABLE [12/2021 - 10/2022]
|
- Radio and display receiver assembly branch wire or connector
- Power source circuit of radio and display receiver assembly
- Radio and display receiver assembly ground circuit
- Radio and display receiver assembly
|