Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced when inspecting auxiliary battery are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Auxiliary battery terminal is disconnected/reconnected | Perform steering sensor zero point calibration | Lane control system | Refer to INITIALIZATION [11/2018 - 12/2021] |
| Pre-collision system | |||
| Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [11/2018 - 10/2022] | |
| Panoramic view monitor system (for HV model) | Refer to INITIALIZATION [11/2018 - 10/2022] | ||
| Reset back door close position | Power back door system (for HV model) | Refer to INITIALIZATION [11/2018 - 10/2023] | |
| Back door lock initialization | Power door lock control system | Refer to INITIALIZATION [11/2018 - ] |
NOTE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) auxiliary battery terminal.
WAITING TIME BEFORE DISCONNECTING CABLE FROM NEGATIVE (-) AUXILIARY BATTERY TERMINAL
| System Name | See Procedure |
|---|---|
| Vehicle enrolled in Toyota Audio Multimedia system or safety connect system | 6 minutes |
| Vehicle not enrolled in Toyota Audio Multimedia system and safety connect system | 1 minute |