Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Before troubleshooting, make sure that the kick door control sensor is not damaged.
- Before troubleshooting, be sure to read Precautions for Hands Free Power Back Door.
Refer to PRECAUTION [11/2018 - 10/2023]
- If the multiplex network door ECU has been removed and installed or replaced, or if any of the connectors has been disconnected, initialize the power back door system.
Refer to INITIALIZATION [11/2018 - 10/2023]
- After performing work, using the Techstream, read the Data List item "Kick Sensor Connection" and check that the kick door control sensor is connected.
- Check the smart key system (for Entry Function, HV Model) first before troubleshooting the power back door system.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - 12/2021] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2021 - ]