Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Inspect fuses for circuits related to this system before performing the following inspection procedure.
- If the replacement, removal and installation of the multiplex network door ECU or disconnection of the connectors of the multiplex network door ECU has been performed, initialize the power back door system.
Refer to INITIALIZATION [11/2018 - 10/2023]
- If the main body ECU (multiplex network body ECU) is replaced, refer to Registration.
- This check is possible only when the power back door function customization setting using the multi-information display in the combination meter assembly is set to ON (initial setting is ON).