LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 48 (Heating / Air Conditioning System (HV) - Diagnostics - Introduction (1 Of 2)) >> AIR CONDITIONING SYSTEM (for HV Model) >> Initialization [11/2018 - 02/2019] >> Initialization [11/2018 - 02/2019]

Initialization [11/2018 - 02/2019]

WARNING: This page is about a different variant/trim than selected.
  1. INITIALIZATION SERVO MOTOR 
    1. Turn the power switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the power switch on (IG).
    4. Press the A/C OFF switch.
    5. Turn the Techstream on.
    6. Enter the following menus: Body Electrical / Air Conditioner / Utility / Servomotor Initialization.
    7. According to the Techstream display, perform servo motor initialization.

      Body Electrical > Air Conditioner > Utility 

      Tester Display
      Servomotor Initialization

      HINT: 

      During initialization, the AUTO indicator light comes on, and then goes off when initialization has finished.

    8. According to the Techstream display, select the Exit switch to finish initialization.
scientia non olet · About LEMON Manuals