LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 43 (Can Communication System (HV) - Circuit Tests (1 Of 6) & Diagnostic Codes) >> CAN COMMUNICATION SYSTEM (for HV Model) >> Steering Angle Sensor Communication Stop Mode [11/2018 - 02/2019] >> Description

Steering Angle Sensor Communication Stop Mode [11/2018 - 02/2019]: Description

WARNING: This page is about a different variant/trim than selected.
Detection Item Symptom Trouble Area
Steering Angle Sensor Communication Stop Mode Any of the following conditions are met:
  • Communication stop for "Spiral cable (Steering Angle Sensor)" is indicated on the "Communication Bus Check" screen of the Techstream.

    Refer to PROBLEM SYMPTOMS TABLE [11/2018 - 02/2019]

  • Communication stop history for "Spiral cable (Steering Angle Sensor)" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Spiral cable (Steering Angle Sensor)" is 6 or more.)

    Refer to PROBLEM SYMPTOMS TABLE [11/2018 - 02/2019]

  • Communication system DTCs (DTCs that start with U) that correspond to "Steering Angle Sensor Communication Stop Mode" in "DTC Combination Table" are output.

    Refer to DTC COMBINATION TABLE [11/2018 - 02/2019]
  • Steering sensor branch wire or connector
  • Power source circuit of steering sensor
  • Steering sensor ground circuit
  • Steering sensor
scientia non olet · About LEMON Manuals