Hybrid Vehicle Control ECU Communication Stop Mode [11/2018 - 02/2019]: Description
WARNING: This page is about a different variant/trim than selected.
| Detection Item |
Symptom |
Trouble Area |
| Hybrid Vehicle Control ECU Communication Stop Mode |
Any of the following conditions are met:
- Communication stop for "Hybrid Vehicle Control" is indicated on the "Communication Bus Check" screen of the Techstream.
Refer to PROBLEM SYMPTOMS TABLE [11/2018 - 02/2019]
- Communication stop history for "Hybrid Vehicle Control" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Hybrid Vehicle Control" is 6 or more.)
Refer to PROBLEM SYMPTOMS TABLE [11/2018 - 02/2019]
- Communication system DTCs (DTCs that start with U) that correspond to "Hybrid Vehicle Control ECU Communication Stop Mode" in "DTC Combination Table" are output.
Refer to DTC COMBINATION TABLE [11/2018 - 02/2019]
|
- Hybrid vehicle control ECU assembly branch wire or connector
- Power source circuit of hybrid vehicle control ECU assembly
- Hybrid vehicle control ECU assembly ground circuit
- Hybrid vehicle control ECU assembly
|