LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 43 (Can Communication System (HV) - Circuit Tests (1 Of 6) & Diagnostic Codes) >> CAN COMMUNICATION SYSTEM (for HV Model) >> DTC B1003: ECU Malfunction [02/2019 - ] >> Procedure

DTC B1003: ECU Malfunction [02/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. RECONFIRM DTC OUTPUT 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Central Gateway / Trouble Codes.

      Body Electrical > Central Gateway > Trouble Codes 

      Result

      Result Proceed to
      DTC B1003 is not output from the central gateway ECU (network gateway ECU) A
      DTC B1003 is output from the central gateway ECU (network gateway ECU) B

    Result: 

    A 

    USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ] 

    Result: 

    B 

    REPLACE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU). Refer to  REMOVAL [02/2019 - 10/2019]  , or refer to  REMOVAL [10/2019 - 08/2020]  , or refer to  REMOVAL [08/2020 - 12/2021]  , or refer to  REMOVAL [12/2021 - 10/2022]  , or refer to  REMOVAL [10/2022 - 10/2023]  , or refer to  REMOVAL [10/2023 - ] 

scientia non olet · About LEMON Manuals