Combination Meter ECU Communication Stop Mode [10/2022 - ]: Description

WARNING: This page is about a different variant/trim than selected.

Detection Item	Symptom	Trouble Area
Combination Meter ECU Communication Stop Mode	Any of the following conditions are met: Communication stop for "Combination Meter" is indicated on the "Communication Bus Check" screen of the Techstream. Refer to PROBLEM SYMPTOMS TABLE [12/2021 - ] Communication stop history for "Combination Meter" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Combination Meter" is 6 or more.) Refer to PROBLEM SYMPTOMS TABLE [12/2021 - ] Communication system DTCs (DTCs that start with U) that correspond to "Combination Meter ECU Communication Stop Mode" in "DTC Combination Table" are output. Refer to DTC COMBINATION TABLE [10/2022 - 10/2023] , or refer to DTC COMBINATION TABLE [10/2023 - ]	Combination meter assembly main wire or connector Power source circuit of combination meter assembly Combination meter assembly ground circuit Combination meter assembly