Installation [02/2019 - ]: Procedure

1. Push the fuel tank pressure sensor (vapor pressure sensor) onto the fuel tank assembly, then install the tube joint clip.
   NOTE:

   • Check that there are no scratches or foreign matter around the connecting parts of the fuel tank pressure sensor (vapor pressure sensor) and fuel suction plate sub-assembly before performing this work.
   • Check that the fuel suction plate sub-assembly is securely inserted to the end of the fuel tank pressure sensor (vapor pressure sensor).
   • Check that the tube joint clip is on the collar of the fuel tank pressure sensor (vapor pressure sensor).
   • After installing the tube joint clip, check that the fuel tank pressure sensor (vapor pressure sensor) cannot be pulled out.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Tube Joint Clip
   *a	O-ring
   *b	Collar

2. Connect the fuel tank pressure sensor (vapor pressure sensor) connector.

Refer to PROCEDURE - Step 6

Refer to INSTALLATION [02/2019 - ]