DTC P062F-44: Hybrid/EV Powertrain Control Module EEPROM Data Memory Failure [06/2020 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC OUTPUT (HEALTH CHECK)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: System Select / Health Check.
- Check for DTCs.
Result
Result Proceed to P062F-44 is output from the hybrid control system. A P062F-44 is output from any system other than the hybrid control system. B - Turn the ignition switch off.
Result:
A
REPLACE HYBRID VEHICLE CONTROL ECU. Refer to REMOVAL [10/2019 - 08/2020] , or refer to REMOVAL [08/2020 - 12/2021] , or refer to REMOVAL [12/2021 - 10/2022] , or refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]
Result:
B
GO TO PERFORM DIAGNOSIS FOR RESPECTIVE SYSTEM