Installation [11/2018 - 02/2019]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL MASS AIR FLOW METER SUB-ASSEMBLY
HINT:

Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

Refer to INITIALIZATION [11/2018 - 08/2020]
1. Install the mass air flow meter sub-assembly with the 2 screws.
  NOTE:
  - If the mass air flow meter sub-assembly has been struck or dropped, replace it.
  - If reusing the mass air flow meter sub-assembly, be sure to inspect the O-ring.
  - Make sure that the O-ring is not cracked or moved out of place when installing the mass air flow meter sub-assembly.
2. Connect the mass air flow meter sub-assembly connector.