LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Engine Control System (A25A-FXS) - Service Information) >> Knock Sensor >> Removal [11/2018 - 02/2019] >> Procedure

Removal [11/2018 - 02/2019]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE INTAKE MANIFOLD 

    Refer to REMOVAL [11/2018 - 02/2019]

  2. REMOVE KNOCK CONTROL SENSOR 
    1. Disconnect the knock control sensor connector.
      GTY868596Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and knock control sensor from the cylinder block sub-assembly.
      NOTE:

      If the knock control sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals