LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Engine Control System (A25A-FXS) - Service Information) >> Knock Sensor >> Removal [02/2019 - 08/2020] >> Procedure

Removal [02/2019 - 08/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE INTAKE MANIFOLD 

    Refer to REMOVAL [02/2019 - 08/2020]

  2. REMOVE KNOCK CONTROL SENSOR 
    1. Disconnect the knock control sensor connector.
      GTY868596Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and knock control sensor from the cylinder block sub-assembly.
      NOTE:

      If the knock control sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals