Removal [11/2018 - 02/2019]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 26
- REMOVE IGNITION COIL ASSEMBLY
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
Disconnect the 4 ignition coil assembly connectors.
- Remove the 4 bolts and 4 ignition coil assemblies from the cylinder head cover sub-assembly.
NOTE:
If a ignition coil assembly has been struck or dropped, replace it.
- REMOVE SPARK PLUG
Refer to PROCEDURE - Step 3