Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Auxiliary battery terminal is disconnected/reconnected | Perform steering sensor zero point calibration | Lane control system | Refer to INITIALIZATION [12/2021 - ] |
| Parking support brake system (for HV model) | |||
| Pre-collision system | |||
| Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [11/2018 - 10/2022] | |
| Panoramic view monitor system (for HV model) | Refer to INITIALIZATION [11/2018 - 10/2022] | ||
| Reset back door close position | Power back door system (for HV model) | Refer to INITIALIZATION [11/2018 - 10/2023] | |
| Back door lock initialization | Power door lock control system | Refer to INITIALIZATION [11/2018 - ] | |
| Inverter with converter assembly | Resolver learning |
|
for AWD with NICKEL METAL HYDRIDE BATTERY: Refer to UTILITY [02/2019 - ] for LITHIUM-ION BATTERY: Refer to UTILITY [06/2020 - ] |
| ECM | Perform Vehicle Identification Number (VIN) registration | DTC P0630-51 is output | Refer to REGISTRATION [08/2020 - ] |
| Grille shutter switch specification information | Vehicle control history (RoB) [X260E] is stored | Refer to INITIALIZATION [12/2021 - 11/2024] | |
| Engine coolant temperature sensor | Inspection after repair |
|
Refer to INITIALIZATION [12/2021 - 11/2024] |
NOTE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) auxiliary battery terminal.
WAITING TIME BEFORE DISCONNECTING CABLE FROM NEGATIVE (-) AUXILIARY BATTERY TERMINAL
| System Name | See Procedure |
|---|---|
| Vehicle enrolled in Toyota Audio Multimedia system or safety connect system | 6 minutes |
| Vehicle not enrolled in Toyota Audio Multimedia system and safety connect system | 1 minute |