LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Engine Control System (A25A-FXS) - Service Information) >> Engine Coolant Temperature Sensor >> Removal [10/2022 - ] >> Procedure

Removal [10/2022 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. DRAIN ENGINE COOLANT 

    Refer to REPLACEMENT [12/2021 - ]

  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Grille Shutter) 

    Refer to PROCEDURE - Step 26 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 26 [10/2023 - ]

  3. REMOVE INLET AIR CLEANER ASSEMBLY (w/ Grille Shutter) 

    See step  3

  4. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE (w/ Grille Shutter) 

    See step  4

  5. REMOVE NO. 2 ENGINE COOLANT TEMPERATURE SENSOR (w/ Grille Shutter) 
    1. Disconnect the No. 2 engine coolant temperature sensor connector.
      GTY920834Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the clip and No. 2 engine coolant temperature sensor from the water outlet.
      GTY920832Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      If the No. 2 engine coolant temperature sensor has been struck or dropped, replace it.

  6. REMOVE INVERTER WITH CONVERTER ASSEMBLY 

    Refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]

  7. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the engine coolant temperature sensor connector.
      GTY868592Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the clip and engine coolant temperature sensor from the water outlet.
      NOTE:

      If the engine coolant temperature sensor has been struck or dropped, replace it.

      GTY868593Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals