Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Inverter with converter assembly	Resolver learning	DTCs are stored Slight vibration at a vehicle speed of 5 km/h (3 mph) or less Shock or vibration during acceleration	for AWD with NICKEL METAL HYDRIDE BATTERY: Refer to UTILITY [02/2019 - ] for LITHIUM-ION BATTERY: Refer to UTILITY [06/2020 - ]
ECM	Perform Vehicle Identification Number (VIN) registration	DTC P0630-51 is output	Refer to REGISTRATION [08/2020 - ]
ECM	Grille shutter switch specification information	Vehicle control history (RoB) [X260E] is stored	Refer to INITIALIZATION [12/2021 - 11/2024] , or refer to INITIALIZATION [11/2024 - ]
Engine coolant temperature sensor	Inspection after repair	Poor idle, etc. Engine start function, etc.	Refer to INITIALIZATION [12/2021 - 11/2024] , or refer to INITIALIZATION [11/2024 - ]