Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Auxiliary battery terminal is disconnected/reconnected | Perform steering sensor zero point calibration | Lane control system | Refer to INITIALIZATION [11/2018 - 12/2021] |
| Parking support brake system (for HV model) | |||
| Pre-collision system | |||
| Lighting system (EXT) (w/ AFS) | |||
| Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [11/2018 - 10/2022] | |
| Panoramic view monitor system (for HV model) | Refer to INITIALIZATION [11/2018 - 10/2022] | ||
| Reset back door close position | Power back door system (for HV model) | Refer to INITIALIZATION [11/2018 - 10/2023] | |
| Back door lock initialization | Power door lock control system | Refer to INITIALIZATION [11/2018 - ] | |
| Replacement of inverter with converter assembly | Resolver learning |
|
Refer to UTILITY [11/2018 - 08/2020] |
| Replacement of ECM | Perform Vehicle Identification Number (VIN) registration | DTC P0630-51 is output | w/ Canister Pump Module: Refer to REGISTRATION [02/2019 - 08/2020] w/o Canister Pump Module: Refer to REGISTRATION [11/2018 - 08/2020] |
| Grille shutter switch specification information | Vehicle control history (RoB) [X260E] is stored | Refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 08/2020] | |
| Replacement of engine coolant temperature sensor | Inspection after repair |
|
w/ Canister Pump Module: Refer to INITIALIZATION [02/2019 - 10/2019]
, or refer to INITIALIZATION [10/2019 - 08/2020] w/o Canister Pump Module: Refer to INITIALIZATION [11/2018 - 08/2020] |
NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.