LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Engine Control System (A25A-FXS) - Service Information) >> Camshaft Timing Control Motor >> Removal [08/2020 - 12/2021] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during cam timing control motor with EDU assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane control system Refer to INITIALIZATION [11/2018 - 12/2021]
Parking support brake system (for HV model)
Pre-collision system
Lighting system (EXT) (w/ AFS)
Memorize steering angle neutral point Parking assist monitor system Refer to INITIALIZATION [11/2018 - 10/2022]
Panoramic view monitor system (for HV model) Refer to INITIALIZATION [11/2018 - 10/2022]
Reset back door close position Power back door system (for HV model) Refer to INITIALIZATION [11/2018 - 10/2023]
Back door lock initialization Power door lock control system Refer to INITIALIZATION [11/2018 - ]
  • Cam timing control motor with EDU assembly (Including removal and installation)
  • Camshaft timing gear assembly (Including removal and installation)
Inspection after repair
  • Poor idle, etc.
  • Engine start function, etc.
Refer to INITIALIZATION [08/2020 - 12/2021]
NOTE:
  • This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

    Refer to PRECAUTION [11/2018 - ]

  • After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) auxiliary battery terminal.
    WAITING TIME BEFORE DISCONNECTING CABLE FROM NEGATIVE (-) AUXILIARY BATTERY TERMINAL

    System Name See Procedure
    Vehicle enrolled in Toyota Audio Multimedia system or safety connect system 6 minutes
    Vehicle not enrolled in Toyota Audio Multimedia system and safety connect system 1 minute