DTC C1697: Camera Position Adjustment Incomplete [11/2018 - 10/2022]: Procedure

1. Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.
   1. Refer to camera view adjustment.

      Refer to CALIBRATION [11/2018 - 10/2022]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [11/2018 - 10/2022]

   Chassis > Circumference Monitoring Camera Control Module > Clear DTCs 

2. Check for DTCs.

   Refer to DTC CHECK / CLEAR [11/2018 - 10/2022]

   Chassis > Circumference Monitoring Camera Control Module > Trouble Codes 

   OK

   DTC C1697 is not output.

   HINT: 

   • If DTC C1697 is output, perform the camera view adjustment again.
   • If DTC C1697 is still output after performing the camera view adjustment 3 times, replace the parking assist ECU.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (CAMERA VIEW ADJUSTMENT IS DEFECTIVE) 

Result: 

NG 

REPLACE PARKING ASSIST ECU. Refer to  REMOVAL [11/2018 - 10/2022]