Disassembly [11/2018 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE SHIFT LEVER HOLE COVER
- Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the shift lever hole cover from the upper console panel sub-assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
NOTE:
Be careful not to damage the shift lever hole cover and upper console panel sub-assembly.
- REMOVE SHIFT POSITION INDICATOR
HINT:
Only perform this procedure when replacement of the shift position indicator is necessary.
- Disengage the clamp to disconnect the wire harness.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
Disengage the 2 claws and 3 screws to remove the shift position indicator from the upper console panel sub-assembly.
- REMOVE LOWER POSITION INDICATOR HOUSING
- Disengage the 4 claws and 2 guides to remove the lower position indicator housing from the shift lock control unit assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
NOTE:
Do not damage the lower position indicator housing.