Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Perform registration after replacing or removing and installing the ultrasonic sensor or clearance warning ECU assembly.
Refer to CALIBRATION [02/2019 - ]
- If a DTC is detected again after the repair, turn the power switch on (IG) and turn the intuitive parking assist system on, and then clear the DTC.
Refer to DTC CHECK / CLEAR [02/2019 - ]
- If C1AE2-96 is output at the same time, check C1AE2-96 first.
Refer to DTC C1AE2-96: Ultrasonic Sensor (Front Left Center) Component Internal Failure [02/2019 - ]