Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery state sensor removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedures | Necessary Procedures | Effect/Inoperative Function when Necessary Procedures not Performed | Link |
|---|---|---|---|
| Battery terminal is disconnected/reconnected | Perform steering sensor zero point calibration | Lane control system | Refer to INITIALIZATION [11/2018 - 12/2021] |
| Parking support brake system (for HV model)* | |||
| Pre-collision system | |||
| Lighting system (EXT) (w/ AFS) | |||
| Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [11/2018 - 10/2022] | |
| Panoramic view monitor system (for HV model) | Refer to INITIALIZATION [11/2018 - 10/2022] | ||
| Reset back door close position | Power back door system (for HV model) | Refer to INITIALIZATION [11/2018 - 10/2023] | |
| Back door lock initialization | Power door lock control system | Refer to INITIALIZATION [11/2018 - ] |
*: When performing learning using the Techstream.
NOTE:
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) auxiliary battery terminal.
WAITING TIME BEFORE DISCONNECTING CABLE FROM NEGATIVE (-) AUXILIARY BATTERY TERMINAL
| System Name | See Procedure |
|---|---|
| Vehicle enrolled in Toyota Audio Multimedia system or safety connect system | 6 minutes |
| Vehicle not enrolled in Toyota Audio Multimedia system and safety connect system | 1 minute |