Installation [11/2018 - ]: Procedure

1. Attach the 2 claws to install the battery state sensor assembly to the battery current sensor holder.
2. Attach the clamp and connect the engine wire to the battery state sensor assembly.
3. Connect the battery state sensor assembly connector.
4. Install the battery state sensor assembly to the auxiliary battery and tighten the nut.

   Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

5. Connect the No. 2 frame wire to the battery state sensor assembly with the nut.

   Torque: 7.6 N.m (77 kgf/cm, 67 in.lbf) 

   NOTE:

   When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.

   Refer to INITIALIZATION [11/2018 - 02/2019] , or refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 06/2020] , or refer to INITIALIZATION [06/2020 - 08/2020] , or refer to INITIALIZATION [08/2020 - 12/2021] , or refer to INITIALIZATION [12/2021 - 10/2022] , or refer to INITIALIZATION [10/2022 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]

Refer to PROCEDURE - Step 5 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 5 [08/2020 - ]

Refer to PROCEDURE - Step 5 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 5 [08/2020 - ]

Refer to PROCEDURE - Step 5 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 5 [08/2020 - ]