LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 182 (Smart Key System (For Start, HV) - Diagnostic Codes (2 Of 2) & Symptom Tests (1 Of 2)) >> SMART KEY SYSTEM (for Start Function, HV Model) >> DTC U0140: Lost Communication with Body Control Module; DTC U0142: Lost Communication with Main Body ECU; DTC U0155: Lost Communication with Combination Meter; DTC U0230: Lost Communication with Rear Gate Module; DTC U0293: Lost Communication With Hybrid Vehicle Control System; DTC U1117: Lost Communication with Accessory Gateway [11/2018 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • When using the Techstream with the power switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
  • After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

HINT: 

When the cable is disconnected and reconnected to the negative (-) auxiliary battery terminal, the power source mode returns to the state it was in before the cable was disconnected.

scientia non olet · About LEMON Manuals