Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

NOTE:

Before replacing the transponder key ECU assembly, refer to the Registration.
Refer to REGISTRATION [02/2019 - 10/2022]
Make sure that no DTCs are output. If any DTCs are output, proceed to the Diagnostic Trouble Code Chart.
After completing repairs, confirm that the problem does not recur.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.