DTC B2794: Unmatched Encryption Code [02/2019 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REGISTRATION OF TRANSMITTER ID
- Register the door control transmitter assembly which caused the DTC to be stored.
Refer to REGISTRATION [02/2019 - 10/2022] , or refer to REGISTRATION [10/2022 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 2
- Register the door control transmitter assembly which caused the DTC to be stored.
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Enter the following menus: Body Electrical / Immobiliser / Trouble Codes.
- Clear the DTCs.
Body Electrical > Immobiliser > Clear DTCs
Result
Proceed to NEXT
Result:
NEXT
See step 3
- CHECK FOR DTC
- Perform "DTC Output Confirmation Operation" procedure.
- Enter the following menus: Body Electrical / Immobiliser / Trouble Codes.
- Check for DTCs.
Body Electrical > Immobiliser > Trouble Codes
Result
Result Proceed to B2794 is not output A B2794 is output B
Result:
A
END (DOOR CONTROL TRANSMITTER ASSEMBLY WAS NOT REGISTERED)
Result:
B
REPLACE DOOR CONTROL TRANSMITTER ASSEMBLY THAT DTC IS OUTPUT