Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during flow shutting valve (water by-pass hose assembly) removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedures | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Auxiliary battery terminal is disconnected/reconnected | Perform steering sensor zero point calibration | Lane control system | Refer to INITIALIZATION [12/2021 - ] |
| Parking support brake system (for HV model)* | |||
| Pre-collision system | |||
| Reset back door close position | Power back door system | Refer to INITIALIZATION [10/2023 - ] | |
| Back door lock initialization | Power door lock control system | Refer to INITIALIZATION [11/2018 - ] | |
| Replacement of inverter with converter assembly | Resolver learning |
|
for AWD with NICKEL METAL HYDRIDE BATTERY: Refer to UTILITY [02/2019 - ] for LITHIUM-ION BATTERY: Refer to UTILITY [06/2020 - ] |
| Replacement of ECM | Perform Vehicle Identification Number (VIN) registration | DTC P0630-51 is output | Refer to REGISTRATION [08/2020 - ] |
| Grille shutter switch specification information | Vehicle control history (RoB) [X260E] is stored | Refer to INITIALIZATION [12/2021 - 11/2024] , or refer to INITIALIZATION [11/2024 - ] |
*: When performing learning using the Techstream.
NOTE:
- After the ignition switch is turned off, the audio and visual system records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 2 minutes before disconnecting the cable from the negative (-) auxiliary battery terminal.
- When the cable is disconnected from the negative (-) auxiliary battery terminal and the security lock setting has been enabled, multi-display operations will be disabled upon next startup unless the password is entered. Be sure to check the security lock setting before disconnecting the cable from the negative (-) auxiliary battery terminal.