LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 121 (Fuel System (A25A-FXS) - Service Information (2 Of 2)) >> FUEL PUMP (w/o Canister Pump Module) >> Reassembly [11/2018 - 08/2020] >> Procedure

Reassembly [11/2018 - 08/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL FUEL PUMP 

    HINT: 

    Perform "Inspection After Repair" after replacing the fuel pump.

    Refer to INITIALIZATION [11/2018 - 08/2020]

    1. Install the fuel pump to the No. 1 cap.
      GTY914880Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Apply gasoline to a new O-ring.
    3. Install the O-ring to the sub-assembly support.
      GTY943091Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Attach the 3 claws and install the No. 1 cap to the sub-assembly support.
    5. Connect the connector to the fuel pump.
    6. Attach the 4 claws and connect the sub-assembly support to the fuel sub-tank sub-assembly.
  2. INSTALL FUEL SENDER GAUGE ASSEMBLY 

    Refer to INSTALLATION [11/2018 - 08/2020] 

scientia non olet · About LEMON Manuals