Removal [02/2019 - 08/2020]: Procedure
- PRECAUTION NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Refer to PRECAUTION [11/2018 - ]
- DISCHARGE FUEL SYSTEM PRESSURE
Refer to PRECAUTION [02/2019 - 08/2020]
- REMOVE DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 2 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 2 [10/2019 - 08/2020]
- REMOVE REAR NO. 2 FLOOR BOARD
Refer to PROCEDURE - Step 3 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 3 [10/2019 - 08/2020]
- REMOVE BATTERY HOLE COVER
Refer to PROCEDURE - Step 4 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 4 [10/2019 - 08/2020]
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 06/2020] , or refer to INITIALIZATION [06/2020 - 08/2020]
- REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
Refer to PROCEDURE - Step 5
- DISCONNECT FUEL TUBE SUB-ASSEMBLY
- Remove the fuel pipe clamp from the fuel tube connector.
- Disconnect the fuel tube sub-assembly from the fuel pump assembly and fuel delivery pipe sub-assembly.
Refer to PRECAUTION [02/2019 - 08/2020]
- Remove the fuel pipe clamp from the fuel tube connector.
- REMOVE NO. 2 WATER BY-PASS PIPE
- Detach the clamp and disconnect the HV air conditioning wire.
- Slide the clip and disconnect the No. 8 water by-pass hose from the No. 2 water by-pass pipe.
- Remove the 2 bolts (A) and disconnect the No. 2 water by-pass pipe from the intake manifold.
- Remove the bolt (B) and No. 2 water by-pass pipe from the cylinder block sub-assembly.
- Detach the clamp and disconnect the HV air conditioning wire.
- REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY WARNING:
To prevent serious injury due to fuel spray from the high-pressure fuel lines, always discharge fuel system pressure before removing any fuel system components.
- Disconnect the connector from the ignition coil assembly.
- Using a 17 mm union nut wrench, loosen the 2 union nuts of the No. 1 fuel pipe sub-assembly.
Union Nut Bolt - Remove the bolt.
- Loosen the 2 bolts of the fuel pump assembly.
- Remove the No. 1 fuel pipe sub-assembly from the fuel delivery pipe and fuel pump assembly.
- Disconnect the connector from the ignition coil assembly.
- REMOVE FUEL PUMP ASSEMBLY NOTE:
When replacing the fuel pump assembly, it is necessary to replace the No. 1 fuel pipe sub-assembly with a new one.
- Disconnect the connector from the fuel pump assembly.
- Remove the 2 bolts, fuel pump assembly and fuel pump flange from the cylinder head cover sub-assembly.
- Remove the O-ring from the fuel pump assembly.
- Remove the fuel pump lifter assembly from the fuel pump lifter guide.
- Remove the fuel pump spacer gasket from the cylinder head cover sub-assembly.
- Disconnect the connector from the fuel pump assembly.