Installation [08/2020 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL NO. 2 FUEL PRESSURE SENSOR

HINT:

Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.

Set the No. 2 fuel pressure sensor to the fuel delivery pipe sub-assembly.

NOTE:

Do not allow dust or dirt to enter the No. 2 fuel pressure sensor.
If a No. 2 fuel pressure sensor is dropped or struck, replace it with a new one.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Temporarily install the No. 2 fuel pressure sensor holder to the No. 2 fuel pressure sensor.

Install the No. 2 fuel pressure sensor holder to the fuel delivery pipe sub-assembly with the bolt.

Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)

INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY
Refer to INSTALLATION [08/2020 - ]
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [08/2020 - 12/2021] , or refer to INITIALIZATION [12/2021 - 10/2022] , or refer to INITIALIZATION [10/2022 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]
INSTALL BATTERY HOLE COVER
Refer to PROCEDURE - Step 3
INSTALL REAR NO. 2 FLOOR BOARD
Refer to PROCEDURE - Step 4
INSTALL DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 5
PERFORM INITIALIZATION
1. Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.
  Refer to INITIALIZATION [08/2020 - 12/2021] , or refer to INITIALIZATION [12/2021 - 11/2024] , or refer to INITIALIZATION [11/2024 - ]