Removal [02/2019 - 08/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.

PRECAUTION
NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Refer to PRECAUTION [11/2018 - ]
DISCHARGE FUEL SYSTEM PRESSURE
Refer to PRECAUTION [02/2019 - 08/2020]
REMOVE DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 2 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 2 [10/2019 - 08/2020]
REMOVE REAR NO. 2 FLOOR BOARD
Refer to PROCEDURE - Step 3 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 3 [10/2019 - 08/2020]
REMOVE BATTERY HOLE COVER
Refer to PROCEDURE - Step 4 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 4 [10/2019 - 08/2020]
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 06/2020] , or refer to INITIALIZATION [06/2020 - 08/2020]
REMOVE INTAKE MANIFOLD
Refer to REMOVAL [02/2019 - 08/2020]

REMOVE FUEL PRESSURE SENSOR

Disconnect the connector from the fuel pressure sensor.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 2 bolts and No. 1 fuel pressure sensor holder from the fuel delivery pipe.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the fuel pressure sensor from the fuel delivery pipe.

NOTE:

Pull and remove the fuel pressure sensor in a straight line to avoid damaging the seal surface of the fuel delivery pipe O-ring.
After removing the fuel pressure sensor, remove any parts remaining on the fuel delivery pipe side.