LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 120 (Fuel System (A25A-FXS) - Service Information (1 Of 2)) >> FUEL MAIN VALVE (w/o Canister Pump Module) >> Installation [11/2018 - 08/2020] >> Procedure

Installation [11/2018 - 08/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL FUEL MAIN VALVE ASSEMBLY 
    1. Apply gasoline to a new O-ring.
    2. Install the spacer and O-ring to the fuel main valve assembly.
      GTY866632Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 O-ring
      *2 Spacer
    3. Install the fuel main valve assembly to the fuel suction with pump and gauge tube assembly.
      NOTE:

      Make sure that the O-ring is not cut or pinched during installation.

    4. Attach the 3 claws and install the No. 3 fuel suction support to the fuel suction with pump and gauge tube assembly.
  2. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY 

    Refer to INSTALLATION [11/2018 - 08/2020]

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [11/2018 - 02/2019] , or refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 06/2020] , or refer to INITIALIZATION [06/2020 - 08/2020]

  4. INSTALL BATTERY HOLE COVER 

    Refer to PROCEDURE - Step 3

  5. INSTALL REAR NO. 2 FLOOR BOARD 

    Refer to PROCEDURE - Step 4

  6. INSTALL DECK BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 5

scientia non olet · About LEMON Manuals