Removal [02/2019 - 08/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.

PRECAUTION
NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Refer to PRECAUTION [11/2018 - ]
REMOVE DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 2 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 2 [10/2019 - 08/2020]
REMOVE REAR NO. 2 FLOOR BOARD
Refer to PROCEDURE - Step 3 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 3 [10/2019 - 08/2020]
REMOVE BATTERY HOLE COVER
Refer to PROCEDURE - Step 4 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 4 [10/2019 - 08/2020]
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 06/2020] , or refer to INITIALIZATION [06/2020 - 08/2020]
REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
Refer to REMOVAL [02/2019 - 08/2020]

REMOVE FUEL MAIN VALVE ASSEMBLY

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Detach the 2 claws and remove the No. 3 fuel suction support from the fuel suction with pump and gauge tube assembly.

Remove the fuel main valve assembly from the fuel suction with pump and gauge tube assembly.

Remove the O-ring and spacer from the fuel main valve assembly.