DTC P0010-01: Camshaft Position "A" Actuator Bank 1 General Electrical Failure [02/2019 - 06/2020]: Procedure

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the cam timing control motor with EDU assembly.

   Refer to REMOVAL [02/2019 - 08/2020]

2. Check if the eccentric shaft of the camshaft timing gear assembly rotates smoothly.
   NOTE:

   If the camshaft is at a position where a valve is about to open, the eccentric shaft may become difficult to rotate.

   OK

   Rotates smoothly.

   HINT: 

   Perform "Inspection After Repair" after replacing the camshaft timing gear assembly, or removing or replacing the cam timing control motor with EDU assembly.

   Refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 08/2020]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY 

Refer to REMOVAL [02/2019 - 08/2020]

Result: 

NG 

REPLACE CAMSHAFT TIMING GEAR ASSEMBLY 

Refer to REMOVAL [02/2019 - 10/2019] , or refer to REMOVAL [10/2019 - 06/2020]