LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 101 (Hybrid Transaxle System (P710) - Service Information (1 Of 2)) >> Transmission Control Cable >> Removal [02/2019 - 08/2020] >> Procedure

Removal [02/2019 - 08/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. SECURE VEHICLE 
    1. Fully apply the parking brake and chock a wheel.
      WARNING:
      • Make sure to apply the parking brake and chock a wheel before performing this procedure.
      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
      GTY655852Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 26 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 26 [10/2019 - 08/2020]

  3. REMOVE INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 3

  4. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 4

  5. REMOVE FRONT FENDER FRONT SPLASH SHIELD LH 

    Refer to PROCEDURE - Step 13 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 13 [10/2019 - 08/2020]

  6. REMOVE FRONT FENDER FRONT SPLASH SHIELD RH 

    Refer to PROCEDURE - Step 14 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 14 [10/2019 - 08/2020]

  7. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 15 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 15 [10/2019 - 08/2020]

  8. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 16 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 16 [10/2019 - 08/2020]

  9. REMOVE FRONT EXHAUST PIPE ASSEMBLY 

    Refer to REMOVAL [02/2019 - 08/2020]

  10. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [11/2018 - 12/2021]

  11. REMOVE NO. 1 CONSOLE BOX DUCT 

    Refer to PROCEDURE - Step 3

  12. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 

    Refer to PROCEDURE - Step 4

  13. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Move the shift lever to N.
    2. Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.
      GTY856872Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Using a screwdriver, disengage the 4 claws and disconnect the transmission control cable assembly with the clip from the No. 1 transmission control cable bracket.
      GTY856871Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Using a screwdriver, disengage the 2 claws and remove the clip from the transmission control cable assembly.
      GTY745662Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. for 2WD:
      GTY856860Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 3 bolts and disconnect the transmission control cable assembly from the inverter with converter assembly.
    6. for AWD:
      GTY856864Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 2 bolts and disconnect the transmission control cable assembly from the inverter with converter assembly.
    7. Remove the 2 nuts and then remove the transmission control cable assembly from the vehicle body.
      GTY930294Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Remove the nut and disconnect the transmission control cable assembly from the vehicle body.
      GTY856862Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals