Removal [10/2019 - 06/2020]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE INVERTER WITH CONVERTER ASSEMBLY
- for 2WD:
Refer to REMOVAL [10/2019 - 08/2020]
- for AWD:
Refer to REMOVAL [10/2019 - 06/2020]
- for 2WD:
- REMOVE MOTOR CABLE WARNING:
Be sure to wear insulated gloves.
- Remove the 2 bolts and connector cover from the hybrid vehicle transaxle assembly.
- Detach the 2 claws to remove the terminal cap from the hybrid vehicle transaxle assembly.
- Using an insulated tool, remove the 6 bolts and motor cable from the hybrid vehicle transaxle assembly.
*a Waterproof Seal NOTE:- Keep the motor cable terminals and their installation area free from foreign matter, water, etc.
- Do not touch the waterproof seal or terminals of the motor cable.
- Cover the hole where the motor cable was installed with tape or equivalent (non-residue type) to prevent entry of foreign matter.
- Remove the 2 bolts and connector cover from the hybrid vehicle transaxle assembly.