LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 101 (Hybrid Transaxle System (P710) - Service Information (1 Of 2)) >> Motor Cable >> Installation [02/2019 - 08/2020] >> Procedure

Installation [02/2019 - 08/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL MOTOR CABLE 
    WARNING:

    Be sure to wear insulated gloves.

    1. Using an insulated tool, install the motor cable to the hybrid vehicle transaxle assembly with the 6 bolts.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

      NOTE:
      • Keep the motor cable terminals and their installation area free from foreign matter, water, etc.
      • Do not touch the waterproof seal or terminals of the motor cable.
    2. Attach the 2 claws to install a new terminal cap to the hybrid vehicle transaxle assembly.
      NOTE:
      • Keep the terminal cap and its installation area free from foreign matter, water, etc.
      • Do not pinch the O-ring.
      • Check that the terminal cap is securely installed.
    3. Temporarily install the connector cover to the hybrid vehicle transaxle assembly with the 2 bolts.
    4. Tighten the 2 bolts to install the connector cover.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

  2. INSTALL INVERTER WITH CONVERTER ASSEMBLY 
scientia non olet · About LEMON Manuals