LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Engine Control System (A25A-FKS) - Diagnostic Codes (7 Of 9)) >> SFI System >> DTC P0705-13: Transmission Range Sensor "A" Circuit Open; DTC P0705-62: Transmission Range Sensor "A" Signal Compare Failure [08/2020 - ] >> Description

DTC P0705-13: Transmission Range Sensor "A" Circuit Open; DTC P0705-62: Transmission Range Sensor "A" Signal Compare Failure [08/2020 - ]: Description

WARNING: This page is about a different car, the 2025 Toyota RAV4, 2024 Toyota RAV4, 2023 Toyota RAV4, 2022 Toyota RAV4, and 2021 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

The park/neutral position switch assembly detects the shift lever position and sends signals to the ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P0705-13 Transmission Range Sensor "A" Circuit Open All switches are off simultaneously for NSW, P, R, N and D for 1 minute or more (2 trip detection logic).
  • Open or short in park/neutral position switch assembly circuit
  • Park/neutral position switch assembly
  • ECM
Comes on DTC stored
  • SAE Code: P0705
  • DTC for Mexico Models: Applies
P0705-62 Transmission Range Sensor "A" Signal Compare Failure Either of the following conditions A or B is met (2 trip detection logic):
A. One of the following conditions (a), (b) or (c) is met for 2 seconds or more:
(a) Any 2 or more of the following signals are on simultaneously:
  • P input signal
  • R input signal
  • D input signal

(b) Any 2 or more of the following signals are on simultaneously:
  • N input signal
  • R input signal
  • D input signal

(c) Any 2 or more of the following signals are on simultaneously:
  • NSW input signal
  • R input signal
  • D input signal

B. Any of the following conditions is met for 2 seconds or more with the shift lever in S:
  • NSW input signal is on
  • P input signal is on
  • N input signal is on
  • R input signal is on
  • Open or short in park/neutral position switch assembly circuit
  • Park/neutral position switch assembly
  • Open or short in transmission control switch circuit
  • Transmission control switch (shift lock control unit assembly)
  • ECM
Comes on DTC stored
  • SAE Code: P0705
  • DTC for Mexico Models: Applies