LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Engine Control System (A25A-FKS) - Diagnostic Codes (8 Of 9)) >> SFI System >> DTC P1283-00: Cold Start Fuel Injection Control Performance #1; DTC P1284-00: Cold Start Fuel Injection Control Performance #2; DTC P1285-00: Cold Start Fuel Injection Control Performance #3; DTC P1286-00: Cold Start Fuel Injection Control Performance #4 [08/2020 - ] >> Description

DTC P1283-00: Cold Start Fuel Injection Control Performance #1; DTC P1284-00: Cold Start Fuel Injection Control Performance #2; DTC P1285-00: Cold Start Fuel Injection Control Performance #3; DTC P1286-00: Cold Start Fuel Injection Control Performance #4 [08/2020 - ]: Description

WARNING: This page is about a different car, the 2025 Toyota RAV4, 2024 Toyota RAV4, 2023 Toyota RAV4, 2022 Toyota RAV4, and 2021 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

To improve emissions immediately after a cold start, cold start multi pulse fuel injection control is performed which divides a single pulse of the direct fuel injector into several smaller pulses.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P1283-00 Cold Start Fuel Injection Control Performance #1 Cold start multi pulse fuel injection control for the No. 1 cylinder is not performed (2 trip detection logic).
  • Direct fuel injector assembly (No. 1 cylinder)
  • Open or short in direct fuel injector assembly circuit
  • ECM
Comes on DTC stored
  • SAE Code: P1283
  • DTC for Mexico Models: Does not apply
P1284-00 Cold Start Fuel Injection Control Performance #2 Cold start multi pulse fuel injection control for the No. 2 cylinder is not performed (2 trip detection logic).
  • Direct fuel injector assembly (No. 2 cylinder)
  • Open or short in direct fuel injector assembly circuit
  • ECM
Comes on DTC stored
  • SAE Code: P1284
  • DTC for Mexico Models: Does not apply
P1285-00 Cold Start Fuel Injection Control Performance #3 Cold start multi pulse fuel injection control for the No. 3 cylinder is not performed (2 trip detection logic).
  • Direct fuel injector assembly (No. 3 cylinder)
  • Open or short in direct fuel injector assembly circuit
  • ECM
Comes on DTC stored
  • SAE Code: P1285
  • DTC for Mexico Models: Does not apply
P1286-00 Cold Start Fuel Injection Control Performance #4 Cold start multi pulse fuel injection control for the No. 4 cylinder is not performed (2 trip detection logic).
  • Direct fuel injector assembly (No. 4 cylinder)
  • Open or short in direct fuel injector assembly circuit
  • ECM
Comes on DTC stored
  • SAE Code: P1286
  • DTC for Mexico Models: Does not apply
RELATED DATA LIST

DTC No. Data List
P1283-00
  • Engine Speed
  • Mass Air Flow Sensor
  • Coolant Temperature
  • Target Fuel Pressure (High)
  • Fuel Pressure (High)
  • High Fuel Pressure Sensor
  • Injection Mode
  • Injection Timing Cylinder #1 (D4)
  • Injection Time Cylinder #1 (D4)
  • Ignition Timing Cylinder #1
P1284-00
P1285-00
P1286-00