DTC B2204-9E: Kick Sensor Stuck ON [10/2023 - ]: Procedure

1. Clear the DTCs.

   Body Electrical > Back Door > Clear DTCs 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Turn the ignition switch to ON and wait for at least 60 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Check for DTCs.

   Body Electrical > Back Door > Trouble Codes 

   Result

   Result	Proceed to
   B2204-9E is not output	A
   B2204-9E is output	B

Result: 

A 

USE SIMULATION METHOD TO CHECK 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]

Result: 

B 

See step  4

1. Disconnect the Q7 kick door control sensor connector.
2. Clear the DTCs.

   Body Electrical > Back Door > Clear DTCs 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. Turn the ignition switch to ON and wait for at least 60 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  6

1. Check for DTCs.

   Body Electrical > Back Door > Trouble Codes 

   Result

   Result	Proceed to
   B2204-9E is not output	A
   B2204-9E is output	B

Result: 

A 

REPLACE KICK DOOR CONTROL SENSOR 

Refer to REMOVAL [10/2023 - ]

Result: 

B 

See step  7

1. Disconnect the R26 multiplex network door ECU connector.
2. Disconnect the Q7 kick door control sensor assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   R26-12 (KSIN) or Q7-3 (KSOT) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MULTIPLEX NETWORK DOOR ECU 

Refer to REMOVAL [10/2023 - ]

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR