Installation [11/2018 - ]: Procedure

1. Apply a small amount of engine oil to the O-ring of the oil pressure control valve assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   O-Ring

2. Using an 8 mm socket wrench, install the oil pressure control valve assembly to the timing chain cover assembly with the bolt.

   Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

   NOTE:

   • When reusing the oil pressure control valve assembly, inspect the O-ring.
   • Make sure that the O-ring is not cracked or does not move out of place during installation.
3. Connect the oil pressure control valve assembly connector.

Refer to PROCEDURE - Step 6 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 6 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 6 [12/2021 - 10/2023] , or refer to PROCEDURE - Step 6 [10/2023 - ]

Refer to PROCEDURE - Step 98 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 98 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 98 [12/2021 - ]